Set Zero States on the Wattbike Atom

Set zero states, sometimes called zero offset, resets the force value of the strain gauge of your Wattbike. This value is used to calculate Wattbike’s proprietary power metrics including Polar View & PES when pedalling.

IMPORTANT: No pressure should be applied to the pedals when pressing ‘Set Zero State’ to ensure the most accurate values.

To set zero states, follow these instructions carefully: 

1. Unplug the Wattbike from the mains for 2 minutes, then plug it back in and turn it on. 

2. Open your Wattbike Hub app.

3. Go to Settings

4. Go to Known Wattbikes

5. Select your Wattbike and ensure that you are connected - the circle next to your serial number willl turn green.

6. Enter into the Advanced Settings

7. Whilst off the bike, rotate your pedals back 1 full rotation, set your right pedal to the 6 o'clock position and ensure that no pressure is applied to pedals. 

8. Under the Set Zero state section, press Set - Note that you will not be notified of the reset happening, but this will have occurred.